Bad Moms Club Tumbler Decal - Clear Cast Decal - Tumbler Decal

*** CLEAR CAST DECALS ***

Clear Cast Decals are perfect for epoxy tumblers, keychains made with UV resin or epoxy and more!! Any areas where you see white on the image will be clear and your tumbler will show through. Due to this feature, the clear cast are not recommended for use on dark backgrounds.

- Printed on clear cast material using specialty inks

- No Sealing Required

- No Water Needed

- No Dry Time Before Applying Epoxy

- Waterproof

- Smudge & Smear proof

- DO NOT use alcohol, acetone, essential oils or any other cleaning solution on these decals.

- The size listed will be either width or height depending on the image. Ex: 2.5 inches wide or 2.5 inches tall

------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

How To Apply:

Dry Method:
1. Prepare a clean and smooth surface.
2. I prefer to cut even closer to the image, but it’s not required.
3. Take a piece of transfer tape and first stick to your clothing once or twice to take some of the stickiness away.
o This will help the decal to stick to transfer onto your prepared surface.
4. Using medium or low tack transfer tape lightly press over the image to pick it up
o Use a little bit lighter pressure than you would use with regular vinyl
5. Position your decal on the tumbler or another smooth clean surface such as your laptop, table, tray, etc.
6. Working from the middle of the decal towards the outside edges, firmly press you’re your surface.
7. You can use your fingers, a credit card or a squeegee to help smooth out the decal.
8. Epoxy as usual.

Wet Method:
1. Prepare a clean and smooth surface.
2. I prefer to cut even closer to the image, but it’s not required.
3. Take a piece transfer tape and first stick to your skin or clothing once or twice to take some of the stickiness away.
o This will help the decal to stick to transfer onto your prepared surface.
4. With the transfer tape, lightly press over the image to pick it up
o Use a little bit lighter pressure than you would use with regular vinyl
5. Lightly mist the Decal Solution (see below for solution recipe) on you clean and smooth surface.
o Spray just enough to dampen the surface but it should not be dripping wet.
6. Position your decal on the tumbler or another smooth clean surface such as your laptop, table, tray, etc.
7. Working from the middle of the decal towards the outside edges, firmly press you’re your surface.
8. You can use your fingers, a credit card or a squeegee to help smooth out the decal.
9. Using a dry paper towel, lightly dab any excess solution from the decal and firmly press out any water that is under the decal.
10. Let air dry
11. Epoxy as usual.

Decal Spray Solution:
Fill 4oz of water in spray bottle, add one drop of dish soap any brand. Swirl in bottle but DONT SHAKE or you'll end up with bubbles.